Zhi-xian Dong, Ming-xian Liu, De-min Jia, 等. SYNTHESIS OF NATURAL RUBBER-g-MALEIC ANHYDRIDE AND ITS USE AS A COMPATIBILIZER IN NATURAL RUBBER/SHORT NYLON FIBER COMPOSITES[J]. Chinese Journal of Polymer Science, 2013,31(8):1127-1138. DOI: 10.1007/s10118-013-1310-z.
Zhi-xian Dong, Ming-xian Liu, De-min Jia, et al. SYNTHESIS OF NATURAL RUBBER-g-MALEIC ANHYDRIDE AND ITS USE AS A COMPATIBILIZER IN NATURAL RUBBER/SHORT NYLON FIBER COMPOSITES[J]. Chinese Journal of Polymer Science, 2013, 31(8): 1127-1138. DOI: 10.1007/s10118-013-1310-z.
Zhi-xian Dong, Ming-xian Liu, De-min Jia, 等. SYNTHESIS OF NATURAL RUBBER-g-MALEIC ANHYDRIDE AND ITS USE AS A COMPATIBILIZER IN NATURAL RUBBER/SHORT NYLON FIBER COMPOSITES[J]. Chinese Journal of Polymer Science, 2013,31(8):1127-1138. DOI: 10.1007/s10118-013-1310-z.DOI:
Zhi-xian Dong, Ming-xian Liu, De-min Jia, et al. SYNTHESIS OF NATURAL RUBBER-g-MALEIC ANHYDRIDE AND ITS USE AS A COMPATIBILIZER IN NATURAL RUBBER/SHORT NYLON FIBER COMPOSITES[J]. Chinese Journal of Polymer Science, 2013, 31(8): 1127-1138. DOI: 10.1007/s10118-013-1310-z.DOI:
SYNTHESIS OF NATURAL RUBBER-g-MALEIC ANHYDRIDE AND ITS USE AS A COMPATIBILIZER IN NATURAL RUBBER/SHORT NYLON FIBER COMPOSITES
-MAH) was synthesized by mixing maleic anhydride (MAH) and natural rubber (NR) in solid state in a torque rheometer using dicumyl peroxide (DCP) as initiator. Then the self-prepared NR-
g
-MAH was used as a compatibilizer in the natural rubber/short nylon fiber composites. Both the functionalization of NR with MAH and the reaction between the modified rubber and the nylon fiber were confirmed by Fourier transform infrared spectroscopy (FTIR). Composites with different nylon short fiber loadings (0
5
10
15 and 20 phr) were compounded on a two-roll mill
and the effects of the NR-
g
-MAH on the tensile and thermal properties
fiber-rubber interaction
as well as the morphology of the natural rubber/short nylon fiber composites were investigated. At equal fiber loading
especially the tensile modulus at 100% strain which was about 1.5 times that of the corresponding un-compatibilized ones. The equilibrium swelling tests proved that the incorporation of NR-
g
-MAH increased the interaction between the nylon fibers and the NR matrix. The crosslink density measured with NMR techniques showed that the NR-
g
-MAH compatiblized composites had lower total crosslink density. The glass transition temperatures of the compatibilized composites were about 1 K higher than that of the corresponding un-compabilized ones. Morphology analysis of the NR/short nylon fiber composites confirmed NR-
g
-MAH improved interfacial bonding between the NR matrix and the nylon fibers. All these results signified that the NR-
g
-MAH could act as a good compatilizer of NR/short nylon fiber composites and had a potential for wide use considering its easy to be prepared and compounded with the composites.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.
Influence of Antioxidants and Deep Eutectic Solvent on Vulcanization Kinetics and Mechanical Behaviors of Natural Rubber/Styrene-Butadiene Rubber Blend and Composites
Revealing the Effect of Non-rubber Components of Natural Rubber on Its Radiation Resistance Performance
Optimizing Sulfur Vulcanization for Enhanced Mechanical Performance of Hevea Latex-Dipped Film: Insights from AFM PeakForce Quantitative Nanomechanical Mapping
End-group and Side-chain Dual-engineering of Selenium-fused Acceptors for 20.08% Efficiency Polymer Solar Cells with Low Energy Loss
Sliding Dynamics of Ring Chain on a Rod-Coil Block Copolymer in Rotaxane
相关作者
Zi-Ye Liu
Yi-Hu Song
Qiang Zheng
En-Tao Luo
Liang Jing
Ling-Min Kong
Yu Peng
Hao Luo
相关机构
MOE Key Laboratory of Macromolecular Synthesis and Functionalization, Department of Polymer Science and Engineering, Zhejiang University
Sichuan Academy of Agricultural Sciences
National Key Laboratory of Advanced Polymer Materials, College of Polymer Science and Engineering, Sichuan University
College of Chemistry and Materials Science, Sichuan Normal University
Department of Chemical Science and Engineering, School of Materials and Chemical Technology, Tokyo Institute of Technology, Ookayama 2-12-1, Meguro-, Tokyo