Irradiation crosslinking of semi-crystalline polyamides was performed by high energy electronswith various dosages. It is known that the melting behavior of the polymers after irradiation is acomplex phenomenon. In company with the wide angle X-ray diffraction and DSC data of irradiatedand unirradiated polyamides it is possible to develop the local order and perfection of the crystallinitiesslightly which resulted from introduction of intermolecular crosslinking in amorphous region

incl-uding in amorphous-crystalline interface and crystalline defect regions due to irradiation.It can be explained that slight increase of melting temperature(Tm) and heat of fusion(△Hf) with increasing dosage for both of higher crystallinity nylon 4 and nylon 6.For irradiated lower crystallinity nylons

in contrast

the Tm and △Hf decrease obviously with increasing dosage.In this case

radiation cross-linking"freeze in" the pre-existing morphology

and then the prevention for reorganization during heating is a dominant effect.The Tm from the second melting for all of the samples were depressed

corresponding with Flory theory.Therefore the crosslinks imposed on the molecules restrained the molecular mobility

and that not only depresses the crystallinity but also increases the imperfection of crystallites when the radiated polymer melted and then recrystallized.These are also reflected in the depression of heat and entropy of fusion as well as the appearance of double melting peaks on the DSC thermograms.