Effect of Functionalized Magnetite Nanoparticles and Diaminoxanthone on the Curing, Thermal Degradation Kinetic and Corrosion Property of Diglycidyl Ether of Bisphenol A-Based Epoxy Resin
|Updated:2021-06-21
|
Effect of Functionalized Magnetite Nanoparticles and Diaminoxanthone on the Curing, Thermal Degradation Kinetic and Corrosion Property of Diglycidyl Ether of Bisphenol A-Based Epoxy Resin
Chinese Journal of Polymer ScienceVol. 32, Issue 11, Pages: 1489-1499(2014)
Affiliations:
Department of Polymer Chemistry, Faculty of Chemistry, University of Mazandaran, Babolsar, Iran
Moslem Mansour Lakouraj, Ghasem Rahpaima, Ehsan Nazarzadeh Zare. Effect of Functionalized Magnetite Nanoparticles and Diaminoxanthone on the Curing, Thermal Degradation Kinetic and Corrosion Property of Diglycidyl Ether of Bisphenol A-Based Epoxy Resin[J]. Chinese Journal of Polymer Science, 2014, 32(11): 1489-1499.
DOI:
Moslem Mansour Lakouraj, Ghasem Rahpaima, Ehsan Nazarzadeh Zare. Effect of Functionalized Magnetite Nanoparticles and Diaminoxanthone on the Curing, Thermal Degradation Kinetic and Corrosion Property of Diglycidyl Ether of Bisphenol A-Based Epoxy Resin[J]. Chinese Journal of Polymer Science, 2014, 32(11): 1489-1499.DOI: 10.1007/s10118-014-1535-5.
Effect of Functionalized Magnetite Nanoparticles and Diaminoxanthone on the Curing, Thermal Degradation Kinetic and Corrosion Property of Diglycidyl Ether of Bisphenol A-Based Epoxy Resin
To prepare a high-performance epoxy resin with excellent thermal
chemical and corrosion stability
diaminoxanthone (DAX) was used to cure diglycidylether of bisphenol-A (DGEBA)-based epoxy resin and blend of DGEBA with functionalized Fe
3
O
4
nanoparticles. Kinetic parameters of curing and thermal degradation of epoxy resin systems were estimated by differential scanning calorimetry (DSC) and thermogravimetric analysis (TGA)
respectively. The 10% weight loss temperature has been increased from 340 ℃ to 366 ℃ and there was an increase in the char yield from 32.6% to 45.3% for the above systems. The corrosion performance of epoxy coated carbon steel was examined by potentiodynamic polarization
along with immersion test in 1.0 mol/L HCl solution. The results showed that epoxy resins cured with DAX had low tendency to corrosion. In addition
the cured epoxy resin containing 10% Fe
3
O
4
had higher anticorrosion activity than bare DGEBA system. The results showed that functionalized Fe
3
O
4
nanoparticles enhanced char formation and improved the thermal stability as well as anticorrosion activity of the resin.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.