CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES
|Updated:2021-06-21
|
CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES
Issue 6, Pages: 553-558(2006)
Affiliations:
Author bio:
Funds:
This work is supported by the Trans-Century Training Program Foundation for Talents of Natural Science by the State Education Commission, Key Project of Chinese Ministry of Education (No. 105041)National Natural Science & Foundation Committee of China (NSFC) (Nos. 90401006, 10434030 and 90301004)State Key Project of Basic Research (2003CB314707).()
DOI:
CLC:O631.3
Published:2006
Accepted:
Scan QR Code
[1].CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES[J].Chinese Journal of Polymer Science,2006(06):553-558.
Hui Jin, Yan-bing Hou, Xian-guo Meng and Feng Teng Key Laboratory of Luminescence and Optical Information, et al. CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES[J]. 2006, (6): 553-558.
[1].CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES[J].Chinese Journal of Polymer Science,2006(06):553-558.DOI:
Hui Jin, Yan-bing Hou, Xian-guo Meng and Feng Teng Key Laboratory of Luminescence and Optical Information, et al. CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES[J]. 2006, (6): 553-558.DOI:
CARRIER PHOTOGENERATION IN POLY(N-VINYL-CARBAZOLE)-BASED PHOTOCONDUCTIVE THIN-FILM DEVICES
photoexcitation processes in the bilayer devices based on inorganic materials and poly(N-vinyl-carbazole) (PVK) were investigated. In order to clarify the roles of inorganic materials in photoconductive properties of bilayer devices
TiO2 and ZnS were chosen to combine with PVK. A model for generation of photocurrent (Iph) in single layer device of PVK was obtained. It is deduced that the recombination rate constant (Pcomb) and the ionization rate constant (γ) of excitons should be considered as the most important factors for Iph. For inorganic materials (TiO2 or ZnS)/PVK bilayer devices
in reverse bias of-4 V
the photocurrent of 115 mA/cm2 in the TiO2/PVK device was observed
but the photocurrent in the ZnS/PVK device was only 10 mA/cm2 under the illumination light of 340 nm and the light intensity of 14.2 mW/cm2. The weaker photocurrent is attributed to the absorption of ZnS within UV region and the energy offset at the interface between PVK and ZnS
which impedes the transport of charge carriers.
Abstract
In this paper
photoexcitation processes in the bilayer devices based on inorganic materials and poly(N-vinyl-carbazole) (PVK) were investigated. In order to clarify the roles of inorganic materials in photoconductive properties of bilayer devices
TiO2 and ZnS were chosen to combine with PVK. A model for generation of photocurrent (Iph) in single layer device of PVK was obtained. It is deduced that the recombination rate constant (Pcomb) and the ionization rate constant (γ) of excitons should be considered as the most important factors for Iph. For inorganic materials (TiO2 or ZnS)/PVK bilayer devices
in reverse bias of-4 V
the photocurrent of 115 mA/cm2 in the TiO2/PVK device was observed
but the photocurrent in the ZnS/PVK device was only 10 mA/cm2 under the illumination light of 340 nm and the light intensity of 14.2 mW/cm2. The weaker photocurrent is attributed to the absorption of ZnS within UV region and the energy offset at the interface between PVK and ZnS
which impedes the transport of charge carriers.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.