EFFECT OF GAS FLOW RATE ON CRYSTAL STRUCTURES OF ELECTROSPUN AND GAS-JET/ELECTROSPUN POLY(VINYLIDENE FLUORIDE) FIBERS
Papers|Updated:2021-06-21
|
EFFECT OF GAS FLOW RATE ON CRYSTAL STRUCTURES OF ELECTROSPUN AND GAS-JET/ELECTROSPUN POLY(VINYLIDENE FLUORIDE) FIBERS
Vol. 27, Issue 4, Pages: 511-516(2009)
Affiliations:
Author bio:
Funds:
DOI:
CLC:
Published:20 July 2009
Accepted:
Scan QR Code
Yi Lin, Yong-yi Yao, Xiao-zhan Yang, et al. EFFECT OF GAS FLOW RATE ON CRYSTAL STRUCTURES OF ELECTROSPUN AND GAS-JET/ELECTROSPUN POLY(VINYLIDENE FLUORIDE) FIBERS[J]. 2009, 27(4): 511-516.
DOI:
Yi Lin, Yong-yi Yao, Xiao-zhan Yang, et al. EFFECT OF GAS FLOW RATE ON CRYSTAL STRUCTURES OF ELECTROSPUN AND GAS-JET/ELECTROSPUN POLY(VINYLIDENE FLUORIDE) FIBERS[J]. 2009, 27(4): 511-516.DOI:
EFFECT OF GAS FLOW RATE ON CRYSTAL STRUCTURES OF ELECTROSPUN AND GAS-JET/ELECTROSPUN POLY(VINYLIDENE FLUORIDE) FIBERS
The effect of gas flow rate on crystal structures of electrospun and gas-jet/electrospun poly(vinylidene fluoride) (PVDF) fibers was investigated. PVDF fibers were prepared by electrospinning and gas-jet/electrospinning of its N
N-dimethylformamide (DMF) solutions. The morphology of the PVDF fibers was investigated by scanning electron microscopy (SEM). With an increase of the gas flow rate
the average diameters of PVDF fibers were decreased.The crystal structures and thermal properties of the PVDF fibers were investigated by attenuated Fourier transform infrared spectroscopy (AT-FTIR)
wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC). It was found that electrospinning and gas-jet/electrospinning of PVDF from its DMF solutions promoted the formation ofβ phase. Moreover
gas-jet/electrospun PVDF fibers exhibited higher crystallinity andβphase content than electrospun fibers did. Similar with electrostatic force
the drawing force of gas jet may induce the conformational change to all-trans (TTTT) planar zigzag conformation
and then promote the formation of theβ phase.
Abstract
The effect of gas flow rate on crystal structures of electrospun and gas-jet/electrospun poly(vinylidene fluoride) (PVDF) fibers was investigated. PVDF fibers were prepared by electrospinning and gas-jet/electrospinning of its N
N-dimethylformamide (DMF) solutions. The morphology of the PVDF fibers was investigated by scanning electron microscopy (SEM). With an increase of the gas flow rate
the average diameters of PVDF fibers were decreased.The crystal structures and thermal properties of the PVDF fibers were investigated by attenuated Fourier transform infrared spectroscopy (AT-FTIR)
wide angle X-ray diffraction (WAXD) and differential scanning calorimetry (DSC). It was found that electrospinning and gas-jet/electrospinning of PVDF from its DMF solutions promoted the formation ofβ phase. Moreover
gas-jet/electrospun PVDF fibers exhibited higher crystallinity andβphase content than electrospun fibers did. Similar with electrostatic force
the drawing force of gas jet may induce the conformational change to all-trans (TTTT) planar zigzag conformation
and then promote the formation of theβ phase.
关键词
Keywords
references
The trial reading is over, you can activate your VIP account to continue reading.